Knowledgebase:
How can I inspect the Observation Context of SPIRE Spectrometer data?
Posted by Mark Kidger on 10 September 2018 04:43 PM

The Herschel Science Centre has produced a short videotutorialĀ guide for users of SPIRE spectrometry data to show how to use the observation context and where to find it.

https://www.youtube.com/watch?v=D66Yxz8waVI&t=413s

This short videotutorialĀ gives an introduction to the Observational Context and how to look at it in the Herschel Science Archive. It describes the two types of products at level-2, for Sparse Mode and Mapping Mode. It looks at the Sparse Mode High+Low resolution mode and the detectors and continues with the Mapping Mode, describing the cube structure and the Spectrum2d table. It then looks at the tar Archive file, how to inspect the Observational Context in HIPE and how to use HIPE with data cubes.
(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments: